PROJECT PROCESS

A project starts with geometry, glass requirements, finished levels, installation junctions and real site access — not with a profile brand name.

WORKFLOW

Eight stages, one coordinated responsibility.

Decisions are separated into control gates so a change in finish, glass build-up or floor level is not lost between architect, fabrication and installation.

Project inputs

Plans, elevations, sections, opening schedule, orientation, visual intent and scope boundaries.

Critical openings

The largest sashes, corners, low thresholds, façade modules and heavy IGUs are checked first.

System and glass

Platform, hardware, IGU build-up, safety, solar control and acoustics are selected as one solution.

Installation junction

Frame position, supports, thermal envelope, membranes, waterproofing, drainage and finished levels are coordinated.

Quotation and revision

The price is tied to a defined configuration. Every change is recorded in a clear revision.

Fabrication release

Dimensions, opening schemes, finish, glass, hardware and special details are checked before production.

Logistics and installation

Stillages, glass mass, crane or vacuum lifter, installation sequence and protection of finished surfaces are planned.

Handover and service

Sash operation, compression, drainage, seals and appearance are checked, followed by operating guidance.

CONTROL POINTS

Four control gates.

Before quotation

Is there enough information to compare the same configuration?

Before fabrication

Are revision, dimensions, openings, glass, finish and hardware frozen?

Before glazing

Are supports, clearances, seals, equipment and the glass route ready?

Before handover

Are adjustment, drainage, seals, appearance and concealed work verified?

BIFORIUM / CONTACT

Have drawings or only an early concept?

Send what is available. We will start with the critical questions rather than an arbitrary price per square metre.

Start the project discussion ↗